poplabikes.blogg.se

1. #WINDOWS 2011 SBS CONSOLE LOG ON DISABLED INSTALL#
2. #WINDOWS 2011 SBS CONSOLE LOG ON DISABLED UPDATE#
3. #WINDOWS 2011 SBS CONSOLE LOG ON DISABLED PLUS#

#WINDOWS 2011 SBS CONSOLE LOG ON DISABLED INSTALL#

Also, we do not install SATA hard drives of any kind into server settings anymore.Adding more RAM for Exchange performance would be our priority before adding more spindles to the RAID 10 set. Note: Exchange 2010 has been designed from the ground up to utilize more RAM.SBS 2011 swap file configuration out of the box:.C: 150GB SS-SBS ( Rename to SBS server name).Name after the amount of storage is the drive label.For clients with around 15 seats or more we are starting to configure a standalone 1U server for virtualization or Hyper-V Cluster directly attached to a Promise VTrak RAID Subsystem (VTE310sD or VTE610sD) for maximum storage flexibility.With the advent of the 300GB and 600GB Intel 320 Series SSDs we are looking to SSD going forward for those clients that require ultra-high performing storage systems.

#WINDOWS 2011 SBS CONSOLE LOG ON DISABLED PLUS#

For our 8-15 seat clients we will configure 5 15K SAS spindles in RAID 5 plus a hot spare depending on their I/O requirements.NEW: RAID 5 with 4x 15K SAS Spindles ( four drives) is now our default RAID setup for small clients.PID, memory usage, maximum memory usage, I/O Bytes (3).Task Manager Process Column Customization.Add a Desktop Toolbar to the Task Bar.Remove the Speaker from the System Tray.Keep in mind that some remote management modules such as Dell’s DRAC may not work if the monitor’s resolution is set too high.Set the desktop resolution for the monitor attached.We do not install System Center Essentials that is provided by Intel on our Intel based SBS 2008 servers.Management suites from the hardware manufacturers will be installed later on in this process.Unplug or disable any extra NICs for now. RAID including RAID monitoring/status software.Have SBS and other VMs poll the standalone DC for their time using the above settings. Clustered: Have the standalone DC polling and set as the authoritative time source for the domain.Then set the SBS VM to poll the host’s IP or hostname for time using the above settings. Configure the host’s firewall to allow NTP polling on the local subnet. Standalone: When virtualizing SBS on a standalone server set the host to poll for the correct time.Blog: Hyper-V- Preparing A High Load VM For Time Skew When installing into a VM set the time.Note that we do not input the Product Key into the OS until we are ready to put the server into production or are on the edge of finishing up a migration.

#WINDOWS 2011 SBS CONSOLE LOG ON DISABLED UPDATE#

The firmware update step is an absolutely critical one for the stability of the server. The following assumes that the server manufacturer’s prep disk was used to update the BIOS, motherboard firmware, RAID controller firmware, backplane firmware, and any other device’s onboard firmware prior to installing the SBS 2008 OS.